Elenco Deluxe Digital / Analog Trainer with Tools Kit Ver Manual de usuario descargar pdf (Pagina 14)

MOUNT COMPONENTS TO PANEL

r Push the illuminated switch into the hole in the top

panel with the lugs as shown in Figure V.

r Install the fuse holder with the side lug in the position

shown in Figure V. Fasten the fuse holder in place with

the nut as shown in Figure V. Unscrew the cap and

insert the fuse into the holder.

r There is a raised area on the back side of the top

panel. Screw the spacer to the raised area by inserting

a 4-40 x 1/4” flat head screw into the hole in the raised

area from the top side of the panel (see Figure W).

r When mounting the breadboard, use the holes shown

in Figure X. Mount the breadboard with two #4 x 1/4”

AB black screws from the back side of the top panel as

shown in Figure W. The negative (blue) stripe should

be on top and the numbers reading from left to right

should start with number 1 (see Figure Y). CAUTION:

Do not remove the paper backing from the back of

the breadboards. Do not over-tighten the black

screws.

Figure X

-13-

Spacer

4-40 x 1/4”

Flat head

screw

Top panel

Breadboard

#4 x 1/4” AB screws

Figure W

Figure Y

Back Side - Lower

Right Corner

Figure V

Side lug

Illuminated switch

Top panel

Plastic washer

Fuse holder

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Sin comentarios

Elenco Deluxe Digital / Analog Trainer with Tools Kit Ver Manual de usuario Pagina 14