Elenco Digital / Analog Trainer Kit Version Manual de usuario Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 52
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
Figure G
Diodes have polarity. Mount them
with the band as shown on the top
legend.
-6-
INSTALL COMPONENTS TO PC BOARD
C11 - 100µF 25V
(see Figure E)
R1 - 120 5% 1/4W Resistor
(brown-red-brown-gold)
C6 - .1µF Mylar (104)
(see Figure D)
J28 - Jumper Wire
(see Figure F)
J6 - Jumper Wire
(see Figure F)
D12 - 1N4001 Diode
D11 - 1N4001 Diode
(see Figure G)
C14 - 100µF 25V Lytic
C17 - 100µF 25V Lytic
(see Figure E)
C10 - .1µF Mylar (104)
(see Figure D)
R2 - 120 5% 1/4W Resistor
(brown-red-brown-gold)
J2 - Jumper Wire
(see Figure F)
J3 - Jumper Wire
(see Figure F)
Figure F
Cut a piece of the #22 bare wire
long enough so that 1/4” of wire
passes through each hole in the
PC board after the wire is formed.
Band
Bottom Left Corner of PC Board
Figure E
These capacitors are polarized. Be
sure to mount them with the “+”
lead in the correct hole as marked
on the PC board. Mount the
capacitor lying flat on the PC board
as shown below.
(+)
(–)
Start Here
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

Comentarios a estos manuales

Sin comentarios